CL5550 - Installation Instructions

KL1000 G3 Installation Instructions [GB]

Installation Instructions

Before Installation

Before installing the lock, load the batteries and familiarise yourself with the Programming and Operating Instructions.

Door Thickness

Your KitLock is supplied ready to fit doors up to 19mm (3/4") thick.
For doors between 19mm (3/4") and 25mm (1") thick, you will need to install the 28.5mm (1 1/8") spare spindle. A 9mm (3/8") spare spindle is also included for sheet metal doors. For guidance on how to swap the spindles, see instructions and diagram below:


  1. Remove the lower 2 fixing screws.
  2. Remove cover plate, spindle and threaded shaft.
  3. Replace with spare spindle and threaded shaft.
  4. Replace cover plate.


Replacing an existing cam lock

  1. Remove existing cam lock.
  2. Place the template on the door, lining up the 16mm (5/8”) spindle hole over the original cam lock hole and mark the fixing hole.
  3. Drill the 6mm (1/4”) fixing hole.
  4. Fit the KitLock to the door.
  5. If required, use the packing pieces (supplied) to centralise the lock.
  6. Secure the lock to the door with the large fixing nut.
  7. Fit the upper fixing bolt.
  8. Select and fit cam using the fixing nut and locking washer. Lock nut in place by folding over washer tabs.
  9. Check operation:
    Public Function: The lock is unlocked by default. Present compatible card to lock the lock. Re-present the card to open.
    Private Function: The lock is locked by default. Present a registered card to open.

New Installation

  1. Place the template on the door and mark the 6mm (1/4”) fixing hole and 16mm (5/8”) spindle hole.
    Note: Ensure positioning of the fixing and spindle holes allow enough clearance for the selected cam.
  2. Drill both holes.
  3. Continue with steps 4-9 above.

Exploded Installation View



    • Related Articles

    • KitLock Slam Latch - Installation Instructions

      Suitable for use with the KitLock KL1000 family: KL1000 Classic, KL1000 Classic+, KL1000 G3, KL1000 G3 NetCode, KL1000 NetCode, KL1000 RFID. SPECIAL NOTE The maximum door thickness when using the Slam Latch is 20mm (3/4”). Before installation, ...

    • KL1100 RFID - Programming and Operating Instructions

      ABOUT KL1100 RFID The KL1100 RFID can operate in Standalone Mode or in Remote Card Authorisation (RCA) Mode. RCA Mode gives the ability to remotely set-up and allocate cards to locks or lock groups  with our offline or cloud based software. ...

    • KL1100 RFID - Installation Instructions & Template

      INSTALLATION Please read carefully: Before installing the lock, read the programming and operating instructions suited to your KL1100 model. Please note, the KL1100 RFID requires a Master Card to be assigned on powering up. Instructions can be found ...

    • KL1100 KeyPad - Installation Instructions & Template

      INSTALLATION Please read carefully: Before installing the lock, read the programming and operating instructions suited to your KL1100 model. Please note, the KL1100 RFID requires a Master Card to be assigned on powering up. Instructions can be found ...

    • CL5500 - Programming and Operating Instructions

      Notice: The C3 Smart App replaced the K3 Connect App on February 14, 2023. For more information on how to download, set up and use C3 Smart with your Codelocks Smart Locks, visit: c3smart.net or contact Codelocks Support . About CL5500 The CL4500 and ...