The KL1000 Classic is supplied with a factory set Master Code (11335577) and User Code (2244), and the Private Use Function enabled.
In this function, the lock will remain locked until a valid 4 digit User Code is entered.
On entry of a valid User Code, the lock will open and remain open for 4 seconds.
Before use, two AAA batteries must be fitted.
CHANGING THE MASTER CODE
#Master Code • 01 • New Master Code • New Master Code ••
Example: #11335577 • 01 • 12345678 • 12345678 ••
Result: The Master Code has been changed to 12345678.
FUNCTIONS
Two functions are available: Private Use (enabled by default) and Public Use.
By enabling Public Use, the lock will remain unlocked until a user enters their own 4 digit User Code to lock.
On re-entry of the same 4 digit code, the lock will unlock until the next 4 digit code is entered.
SET PUBLIC USE
#Master Code • 24 ••
Example: #11335577 • 24 ••
Result: Public Use is now enabled.
SET PRIVATE USE
#Master Code • 26 ••
Example: #11335577 • 26 ••
Result: Private Use is now enabled. The default User Code is 2244.
Use Program 02 to add or change User Codes.
ADD OR CHANGE A USER CODE (PRIVATE FUNCTION)
#Master Code • 02 • User Code ••
Example: #11335577 • 02 • 9999 ••
Result: The User Code has been changed to 9999.
Note: Use Program 03 to delete User Codes.
INSTALLATION INSTRUCTIONS
REPLACING AN EXISTING CAM LOCK
- Remove existing cam lock.
- Place the template on the door, lining up the 16mm (5/8”) spindle hole over the original cam lock hole and mark the fixing hole.
- Drill the 6mm (1/4”) fixing hole.
- Fit the KitLock to the door.
- If required, use the packing pieces (supplied) to centralise the lock.
- Secure the lock to the door with the large fixing nut.
- Fit the upper fixing bolt.
- Select and fit cam using the fixing nut and locking washer. Lock nut in place by folding over washer tabs.
- Check operation:
Public Function: The lock is unlocked by default. Enter 2244 to lock the lock. Reenter 2244 to open.
Private Function: The lock is locked by default. Enter 2244 to open. - If the lock is functioning correctly, change the default Master Code and apply any programming changes that you require.
NEW INSTALLATION
- Place the template on the door and mark the 6mm (1/4”) fixing hole and 16mm (5/8”) spindle hole.
Note: Ensure positioning of the fixing and spindle holes allow enough clearance for the selected cam. - Drill both holes.
- Continue with steps 4-10 above.
GSG_KL1000Classic_v1:0122